How to Use a Kreepy Krauly Turn off the pool’s water filtration pump. Place the Kreepy Krauly into the shallow end of the pool and allow it to sink to the bottom. Fill the Kreepy Krauly hose with water from the garden hose. Connect the water-filled hose to the pool inlet hole, or to the skimmer hole if you do not have a dedicated inlet. Click to see full answer. Herein, where do you put the weights on a creepy crawly? Weight Placement 1 weight: 4 to 12 inches from Kreepy Krauly’s swivel head. More than 4 feet, but less than 7 feet 2 weights: one 4 to 12 inches and one 6 feet from the swivel head.Subsequently, question is, how long should a creepy crawly hose be? Kreepy Krauly comes with 40 ft. of hose and 2 hose weights. The hose should be long enough to reach the furthest part of the pool, plus one hose length. A Kreepy hose longer than needed will cause problems, and if too short, it won’t clean the entire pool. In this regard, why is my pool creepy crawly not moving? If Kreepy Krauly is not moving or not pulsating. Check that the main drain and all suction lines are closed, except for the suction line to which Kreepy Krauly is attached (usually a skimmer). Check for debris in the filter or pump basket. Debris may prevent flapper movement.Does kreepy krauly clean walls?It cleans the walls if the suction power is balanced correctly: not too much suction and not too little either. It cleans the walls well enough.
ncG1vNJzZmivp6x7pLHLnpmroaSesrSu1LOxZ5ufonuotI6hprBllKR6urvUZqysnV2WeqS%2BxJ6nsmWTp664uNho